Airwrap 2 Sides Fitting Instructions

Attach short piece to drop-side or cot front rail

1. Place inside cot/crib with grip tape facing the slats, see photo 1.
2. Wrap one end on the last slat (not the corner).
3. Loop end around single slat only, as in photo 2. to ensure maximum grip tape contact.
4. Fasten top and bottom grip tape evenly to ensure a firm fit.
5. Pull and do the same at the other end.
6. Ensure AIRWRAP is even on both sides.
7. Tighten by readjusting either end until AIRWRAP is fitted firmly and securely.
8. The bottom edge of the AIRWRAP should sit just under the surface level of the mattress.

Attach second short piece to rear side rail

1. Place inside cot/crib with grip tape facing the slats, see photo 1.
2. Wrap one end on the last slat (not the corner).
3. Loop end around single slat only, as in photo 2. to ensure maximum grip tape contact.
4. Fasten top and bottom grip tape evenly to ensure a firm fit.
5. Pull and do the same at the other end.
6. Ensure AIRWRAP is even on both sides.
7. Tighten by readjusting either end until AIRWRAP is fitted firmly and securely.
8. The bottom edge of the AIRWRAP should sit just under the surface level of the mattress.

IMPORTANT
There are many cot types available. Please ensure this product is suitable for your cot. Please ensure it is fitted according to instructions at all times while baby is in the cot. If this product is loose, it may pose an entanglement risk. If AIRWRAP™ can not be fitted securely to your cot, please do not use.

EASY FITTING TIP
Attach pieces well higher than the mattress, once at desired tension, slide AIRWRAP™ down the rails, to sit just below the mattress level.

USING A FLAT SHEET AND BLANKET
Position AIRWRAP™ below mattress surface level after tucking baby in. This will assist in keeping AIRWRAP™ at desired height during sleep time.

View Airwrap 4 sides fitting instructions here